Circural interpolation G02, G03
Circular interpolation is done using G02 or G03 code. G02 is clockwise circular interpolation and G03 is counter clockwise circular interpolation. Parameters I , J ,K specifies center of circle from the current point. I, J, K parameters match X, Y, Z axes respective.
| N01 | M216 | Turn on load monitor |
| N02 | G21 | Metric unit mode m / mm |
| N03 | G90 | Absolute coordinates |
| N04 | G00 X50 Z10 | Move tool close to work piece |
| N05 | G50 S2000 | Set the maximum revolution per minute |
| N06 | T0303 M6 | Set tool 3 with tool ofset 3, change tool |
| N07 | G96 S280 F0.1 M42 M03 M08 | Constat surface speed, 280 m/min , 0.1 mm feed rate , Hight spindle gear, Start spindle CW rotation, Turn the mist coolant on |
| N08 | G00 X32 Z0 | Rapid movement to point X32, Z0 |
| N10 | G01 X0 | Linear move to X0 ( and Z0 defined previously) at feed rate 0.1 mm |
| N11 | G01 Z1 | Linear move to Z1 |
| N12 | G00 X28 | Rapid linear move to X28 |
| N13 | G01 Z0 | Linear move to Z0 |
| N14 | G01 X30 Z-2 | Linear move to X30 Z-2 |
| N15 | G01 Z-30 | Linear move to Z-30 |
| N16 | G02 X45 Z-51.21 I30 K0 | Radial clockwise interpolation from current point (X30, Z-30) to point (X45, Z-51.21) with radius 30 and center at (X60 Z-30) |
| N17 | G01 X48 | Linear move to X48 Z-45 |
| N18 | G00 X50 Z10 | Move to start point |
| N19 | M215 | Turn the load monitor off |
| N20 | M30 | Programm stop |